Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 80/970
Global Config
6.2.1.11 description
This command is used to create an alpha-numeric description of the port.
Syntax
description <description>
no description
no - This command removes the description of the port.
Default Setting
None
Command Mode
Interface Config
6.2.1.12 mdi
Note:The 10-Giga Interface will not provide the following command
This command is used to configure the physical port MDI/MDIX state.
Syntax
mdi {auto|across|normal}
no mdi
auto - This type is auto selecting cable type.
across - This type is only allowed the Across-over cable.
normal - This type is only allowed the Normal cable.
no - This command restore the port mode to Auto.
Default Setting
To Next Page
Loading...
Need help?
General
