QUANTA LB4M - Show Ip Pimsm Rp

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 538/970
all - this command represents all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Valid slot and port number separated by forward slashes.
IP Address: This field displays the IP Address of the neighbor on an interface.
Up Time: This field indicates the time since this neighbor has become active on this
interface.
Expiry Time: This field indicates the expiry time of the neighbor on this interface.
8.5.1.6 show ip pimsm rp
This command displays the PIM information for candidate Rendezvous Points (RPs) for all IP
multicast groups or for the specific <group-address> <group-mask> provided in the command.
The information in the table is displayed for each IP multicast group.
Syntax
show ip pimsm rp {<group-address> <group-mask> | candidate | all}
< group-address > - the IP multicast group address.
< group-mask > - the multicast group address mask.
candidate - this command display PIM-SM candidate-RP table information.
all - this command display all group addresses.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Group Address: This field specifies the IP multicast group address.
Group Mask: This field specifies the multicast group address subnet mask.
Address: This field displays the IP address of the Candidate-RP.
Hold Time: This field displays the hold time of a Candidate-RP.