QUANTA LB4M - Tunnel Destination; Tunnel Mode Ipv6 Ip; Loopback Interface Commands

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 553/970
9.1.2.3 tunnel destination
This command specifies the destination transport address of the tunnel.
Syntax
tunnel destination {<ipv4-address>}
<ipv4-address> - A valid IP Address.
Default Setting
None
Command Mode
Interfacel Config
9.1.2.4 tunnel mode ipv6ip
This command specifies the mode of the tunnel.
Syntax
tunnel mode ipv6ip
Default Setting
None
Command Mode
Interfacel Config
9.2 Loopback Interface Commands
The commands in this section describe how to create, delete, and manage loopback interfaces.
A loopback interface is always expected to be up. This interface can provide the source
address for sent packets and can receive both local and remote packets. The loopback