Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 415/970
Command Mode
Global Config.
7 Routing Commands
7.1 Address Resolution Protocol (ARP) Commands
7.1.1 Show Commands
7.1.1.1 show ip arp
This command displays the Address Resolution Protocol (ARP) cache.
Syntax
show ip arp
Default Setting
None
Command Mode
Privileged Exec
Display Message
Age Time: Is the time it takes for an ARP entry to age out. This value was configured into the
unit. Age time is measured in seconds.
Response Time: Is the time it takes for an ARP request timeout. This value was configured
into the unit. Response time is measured in seconds.
Retries: Is the maximum number of times an ARP request is retried. This value was
configured into the unit.
Cache Size: Is the maximum number of entries in the ARP table. This value was configured
into the unit.
Dynamic renew mode: Displays whether the ARP component automatically attempts to
renew dynamic ARP entries when they aged out.
Total Entry Count Current/Peak: Field listing the total entries in the ARP table and the peak
entry count in the ARP table.
Static Entry Count Configured/Active/Max: Field listing configured static entry count,
active static entry count, and maximum static entry count in the ARP table.
To Next Page
Loading...
Need help?
General
