Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 828/970
The range is 1 to 255. The OSPF specification (RFC 2328) requires that preferences
must be given to the routes learned via OSPF in the following order: intra < inter < type-1
< type-2.
OSPF Type-1 - The OSPF type-1 route preference value in the router. The default value
is 13. The range is 1 to 255. The OSPF specification (RFC 2328) requires that
preferences must be given to the routes learned via OSPF in the following order: intra <
inter < type-1 < type-2.
OSPF Type-2 - The OSPF type-2 route preference value in the router. The default value
is 150. The range is 1 to 255. The OSPF specification (RFC 2328) requires that
preferences must be given to the routes learned via OSPF in the following order: intra <
inter < type-1 < type-2.
RIP - The RIP route preference value in the router. The default value is 15. The range is 1
to 255.
Non-Configurable Data
Local - This field displays the local route preference value.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is
performed.
11.2.3.9 Managing VLAN Routing
11.2.3.9.1. Configuring VLAN Routing
Selection Criteria
To Next Page
Loading...
Need help?
General
