Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 488/970
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for
RIP version 2, both to receive packets from either format, or none to not allow any RIP control
packets to be received
Syntax
ip rip receive version {rip1 | rip2 | both | none}
no ip rip receive version
no - This command configures the interface to allow RIP control packets of the default
version(s) to be received.
Default Setting
Both
Command Mode
Interface Config
7.6.2.13 ip rip send version
This command configures the interface to allow RIP control packets of the specified version to
be sent.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP
version 1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2
for sending RIP version 2 using multicast, or none to not allow any RIP control packets to be
sent.
Syntax
ip rip send version {rip1 | rip1c | rip2 | none}
no ip rip send version
no - This command configures the interface to allow RIP control packets of the default
version to be sent.
Default Setting
To Next Page
Loading...
Need help?
General
