To Next Page

To Previous Page

UANTA COMPUTER INC.

Layer 2,3,IPv6+QoS Switch

_____________________________________________________________________________

Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 526/970

no - This command deletes a static route in the static mcast table. The <sourceipaddr> is

the IP address of the multicast packet source.

Default Setting

None

Command Mode

Global Config

8.3.2.3 no ip mcast mroute

This command is used to clear entries in the mroute table. The all parameters is used to clear

all entries.

The source parameter is used to clear the routes in the mroute table entries containing the

specified <sourceipaddr> or <sourceipaddr> [groupipaddr] pair. The source address is the

source IP address of the multicast packet. The group address is the Group Destination IP

address of the multicast packet.

The group parameter is used to clear the routes in the mroute table entries containing the

specified <groupipaddr>. The group address is the Group Destination IP address of the

multicast packet.

Syntax

no ip mcast mroute {group <groupipaddr> | source <sourceipaddr> [<groupipaddr>] |

all}

< groupipaddr > - the IP address of the destination of the multicast packet.

< sourceipaddr > - the IP address of the multicast packet source.

all - This command is used to clear all entries.

Default Setting

None

Command Mode

Global Config

QUANTA LB4M User Manual

Questions and Answers: