Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 206/970
Syntax
ip http secure-port
<portid>
no ip http secure-port
<portid> - SSLT Port value.
no - This command is used to reset the SSLT port to the default value.
Default Setting
443
Command Mode
Global Config
6.3.6.6 ip http secure-server
This command is used to enable the secure socket layer for secure HTTP.
Syntax
ip http secure-server
no ip http secure-server
no - This command is used to disable the secure socket layer for secure HTTP.
Default Setting
Disabled
Command Mode
Global Config
6.3.6.7 ip http secure-protocol
This command is used to set protocol levels (versions). The protocol level can be set to TLS1,
SSL3 or to both TLS1 and SSL3.
To Next Page
Loading...
Need help?
General
