Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 360/970
<size> - Use the optional size parameter to specify the size, in bytes, of the payload of the
Echo Requests sent. Range is 0 to 65507 bytes.
Default Setting
None
Command Mode
Previledge Mode
6.17.8.2 traceroute ipv6
This command is used to discover the routes that packets actually take when traveling to their
destination through the network on a hop-by-hop basis. The <ipv6-address> parameter must
be a
val
id
IPv6
address.
The
optional
<port>
para
meter is
the
U
DP p
ort u
sed
as
the
destination
of packets sent as part of the traceroute. This port should be an unused port on the destination
system. The range for
<port> is 0 (zero) to 65535
.The de
fault value is 33434.
Syntax
traceroute ipv6 <ipv
6-address> [<port
>]
<ipv6-address> - A valid IPv6 address.
<port> - A valid decimal integer in the range of 0 (zero) to 65535.
Default Setting
None
Command Mode
Privileged Exec
6.17.9 logging cli-command
This command enables the CLI command Logging feature. The Command Logging component
enables the switch to log all Command Line Interface (CLI) commands issued on the system.
To Next Page
Loading...
Need help?
General
