QUANTA LB4M - Router Discovery Protocol Commands; Show Ip Irdp; Ip Irdp

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 489/970
Rip2
Command Mode
Interface Config
7.7 Router Discovery Protocol Commands
7.7.1 show ip irdp
This commands displays the router discovery information for all interfaces, or a specified
interface.
Syntax
show ip irdp {<slot/port> | all}
<slot/port> - Show router discovery information for the specified interface.
<all> - Show router discovery information for all interfaces.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
Ad Mode Displays the advertise mode which indicates whether router discovery is enabled
or disabled on this interface.
Advertise Address: Addresses to be used to advertise the router for the interface.
Max Int Displays the maximum advertise interval which is the maximum time allowed
between sending router advertisements from the interface in seconds.
Min Int Displays the minimum advertise interval which is the minimum time allowed
between sending router advertisements from the interface in seconds.
Hold Time Displays advertise holdtime which is the value of the holdtime field of the router
advertisement sent from the interface in seconds.
Preferences Displays the preference of the address as a default router address, relative to
other router addresses on the same subnet.
7.7.2 ip irdp
This command enables Router Discovery on an interface.
Syntax