Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 544/970
no - This command resets the transmission frequency of hello messages between PIM
enabled neighbors to the default value.
Default Setting
30
Command Mode
Interface Config
8.5.2.8 ip pimsm cbsrpreference
This command is used to configure the CBSR preference for a particular PIM-SM interface.
The range of CBSR preference is –1 to 255.
Syntax
ip pimsm cbsrpreference <-1 - 255>
no ip pimsm cbsrpreference
<-1 - 255> - The preference value for the local interface.
no - This command is used to reset the CBSR preference for a particular PIM-SM
interface to the default value.
Default Setting
0
Command Mode
Interface Config
8.5.2.9 ip pimsm cbsrhashmasklength
This command is used to configure the CBSR hash mask length to be advertised in bootstrap
messages for a particular PIM-SM interface. This hash mask length will be used in the hash
algorithm for selecting the RP for a particular group. The valid range is 0 - 32. The default value
is 30.
Syntax
To Next Page
Loading...
Need help?
General
