QUANTA LB4M - Sntp Unicast Client Poll-Interval; Sntp Unicast Client Poll-Timeout

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 300/970
Syntax
sntp client port <portid> [<6-10>]
no sntp client port
<portid> - SNTP client port id.
<6-10> - Polling interval. It's 2^(value) seconds where value is 6 to 10.
no - Resets the SNTP client port id.
Default Setting
The default portid is 123.
Command Mode
Global Config
6.10.2.4 sntp unicast client poll-interval
This command will set the poll interval for SNTP unicast clients in seconds.
Syntax
sntp unicast client poll-interval <6-10>
no sntp unicast client poll-interval
<6-10> - Polling interval. It's 2^(value) seconds where value is 6 to 10.
no - This command will reset the poll interval for SNTP unicast clients to its default value.
Default Setting
The default value is 6.
Command Mode
Global Config
6.10.2.5 sntp unicast client poll-timeout