Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 782/970
11.2.3.2 Managing IP Interfaces
11.2.3.2.1. Configuring IP
Use this menu to configure routing parameters for the switch as opposed to an interface.
Configurable Data
Routing Mode - Select enable or disable from the pulldown menu. You must enable
routing for the switch before you can route through any of the interfaces. The default
value is disable.
IP Forwarding Mode - Select enable or disable from the pulldown menu. This enables or
disables the forwarding of IP frames. The default value is enable.
Non-Configurable Data
Default Time to Live - The default value inserted into the Time-To-Live field of the IP
header of datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol.
Maximum Next Hops - The maximum number of hops supported by the switch. This is a
compile-time constant.
Command Buttons
To Next Page
Loading...
Need help?
General
