Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 781/970
Remove IP Address - This appears only if the user selects Specific Dynamic/Gateway
Entry or Specific Static Entry in the Remove from Table Drop Down List. Allows the user
to enter the IP Address against the entry that is to be removed from the ARP Table.
Slot/Port - The routing interface associated with the ARP entry.
Non-Configurable Data
Total Entry Count - Total number of Entries in the ARP table.
Peak Total Entries - Highest value reached by Total Entry Count. This counter value is
restarted whenever the ARP table Cache Size value is changed.
Active Static Entries - Total number of Active Static Entries in the ARP table.
Configured Static Entries - Total number of Configured Static Entries in the ARP table.
Maximum Static Entries - Maximum number of Static Entries that can be defined.
IP Address - The IP address of a device on a subnet attached to one of the switch's
routing interfaces.
MAC Address - The unicast MAC address for the device. The format is six two-digit
hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
Slot/Port - The routing interface associated with the ARP entry.
Type - The type of the ARP entry:
Local - An ARP entry associated with one of the switch's routing interface's MAC
addresses
Gateway - A dynamic ARP entry whose IP address is that of a router
Static - An ARP entry configured by the user
Dynamic - An ARP entry which has been learned by the router
Age - Age since the entry was last refreshed in the ARP Table. The format is hh:mm:ss.
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain
the new values across a power cycle, you must perform a save.
To Next Page
Loading...