QUANTA LB4M - Area Default-Cost (Ospfv3); Ipv6 Router Ospf

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 589/970
hour).
Syntax
ipv6 ospf transmit-delay <seconds>
no ipv6 ospf transmit-delay
<no> - This command sets the default OSPF Transit Delay for the specified interface.
Default Setting
1
Command Mode
Interface Config
9.4.2.11 ipv6 router ospf
Use this command to enter Router OSPFv3 Config mode.
Syntax
ipv6 router ospf
Default Setting
None
Command Mode
Global Config
9.4.2.12 area default-cost (OSPFv3)
This command configures the monetary default cost for the stub area. The operator must
specify the area id and an integer value between 1-16777215.
Syntax
area <areaid> default-cost <1-16777215>
<areaid> - Area ID.