QUANTA LB4M - Dot1 X Max-Req; Dot1 X Max-User

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 275/970
< single-host > - Sets single mode.
< multi-host > - Sets multi mode.
no - This command sets authentication mode to default value.
Default Setting
Multi-host
Command Mode
Interface Config
6.8.3.8 dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port
will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The
<1-10> value must be in the range 1 - 10.
Syntax
dot1x max-req <1-10>
no dot1x max-req
<1-10> - maximum number of times (Range: 1 – 10).
no - This command sets the maximum number of times the authenticator state machine
on this port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant to the default value, that is, 2.
Default Setting
2
Command Mode
Interface Config
6.8.3.9 dot1x max-user
This command configures the maximum users to a specified port, The system’s default
maximum users of an interface has no limitation. If ‘no dot1x max-users’ command is
executed, the system will reset the maximum users to infinity. If the maximum users is specified