Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 507/970
This command sets administrative mode of DVMRP in the router to active. IGMP must be
enabled before DVMRP can be enabled.
Syntax
ip dvmrp
no ip dvmrp
no - This command sets administrative mode of DVMRP in the router to inactive. IGMP
must be enabled before DVMRP can be enabled.
Default Setting
Disabled
Command Mode
Global Config
This command sets the administrative mode of DVMRP on an interface to active.
Syntax
ip dvmrp
no ip dvmrp
no - This command sets administrative mode of DVMRP on an interface to inactive.
Default Setting
Disabled
Command Mode
Interface Config
8.1.2.2 ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP
messages as the cost to reach this network.
To Next Page
Loading...
Need help?
General
