Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 570/970
an integer between the value of the router advertisement transmission interval and 9000. A
value of zero means this router is not to be used as the default router.
Syntax
ipv6 nd ra-lifetime <lifetime>
no ipv6 nd ra-lifetime
no – This command resets router lifetime to the default value.
Default Setting
1800
Command Mode
Interface Config
9.3.2.13 ipv6 nd reachable-time
This command sets the router advertisement time to consider a neighbor reachable after
neighbor discovery confirmation. Reachable time is specified in milliseconds. A value of zero
means the time is unspecified by the router.
Syntax
ipv6 nd reachable-time <0 - 4294967295>
no ipv6 nd reachable-time
no – This command means reachable time is unspecified for the router.
Default Setting
0
Command Mode
Interface Config
9.3.2.14 ipv6 nd suppress-ra
To Next Page
Loading...
Need help?
General
