Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 527/970
8.3.2.4 ip mcast boundary
This command adds an administrative scope multicast boundary specified by <groupipaddr>
and <mask> for which this multicast administrative boundary is applicable. <groupipaddr> is a
group IP address and <mask> is a group IP mask.
Syntax
ip mcast boundary <groupipaddr> <mask>
no ip mcast boundary <groupipaddr> <mask>
< groupipaddr > - the multicast group address for the start of the range of addresses to
be excluded. The address must be in the range of 239.0.0.0 through 239.255.255.255.
< mask > - mask to be applied to the multicast group address.
no - This command deletes an administrative scope multicast boundary specified by
<groupipaddr> and <mask> for which this multicast administrative boundary is applicable.
<groupipaddr> is a group IP address and <mask> is a group IP mask.
Default Setting
None
Command Mode
Interface Config
8.3.2.5 ip multicast ttl-threshold
This command applies the given <ttlthreshold> to a routing interface. The <ttlthreshold> is the
TTL threshold which is to be applied to the multicast Data packets which are to be forwarded
from the interface. The value for <ttlthreshold> has range from 0 to 255.
Syntax
ip multicast ttl-threshold <0 - 255>
no ip multicast ttl-threshold
< 0 - 255 > - the TTL threshold.
no - This command applies the default <ttlthreshold> to a routing interface. The
<ttlthreshold> is the TTL threshold which is to be applied to the multicast Data packets
which are to be forwarded from the interface.
To Next Page
Loading...