QUANTA LB4M - Maximum-Paths (Ospfv3); Redistribute (Ospfv3)

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 601/970
9.4.2.33 maximum-paths (OSPFv3)
This command sets the number of paths that OSPF can report for a given destination where
<maxpaths> is platform dependent.
Syntax
maximum-paths <1-2>
no maximum-paths
<1-2> - The maximum number of paths that OSPF can report for a given destination. The
range of the value is 1 to 2.
<no> - This command resets the number of paths that OSPF can report for a given
destination back to its default value.
Default Setting
1
Command Mode
Router OSPFv3 Config.
9.4.2.34 redistribute (OSPFv3)
This command configures the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers.
Syntax
redistribute {static | connected} [metric <0-16777214>] [metric-
type {1 | 2}] [tag
<0-4294967295>]
no redistribute { static | connected} [metric] [metric-type] [tag]
<0-16777215> - The range of metric is 0 to 16777214.
<0-4294967295> - The range of tag is 0 to 4294967295.
Default Setting
Metric is unspecified.
Type is 2.
Tag is 0.