Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 743/970
Last Querier Version - Displays the IGMP protocol version of the last querier from which
a query was snooped on the VLAN.
Operational Max Response Time - Displays maximum response time to be used in the
queries that are sent by the Snooping Querier.
11.2.2.15 Managing Port-Channel
11.2.2.15.1. Configuring Port-Channel Configuration Page
Selection Criteria
Port Channel Name – You can use this screen to reconfigure an existing Port Channel, or
to create a new one. Use this pull down menu to select one of the existing Port Channels,
or select 'Create' to add a new one. There can be a maximum of 6 Port Channels.
Configurable Data
Port Channel Name - Enter the name you want assigned to the Port Channel. You may
enter any string of up to 15 alphanumeric characters. A valid name has to be specified in
order to create the Port Channel.
Link Trap - Specify whether you want to have a trap sent when link status changes. The
factory default is enable, which will cause the trap to be sent.
Administrative Mode - Select enable or disable from the pull down menu. When the Port
Channel is disabled no traffic will flow and LACPDUs will be dropped, but the links that
form the Port Channel will not be released. The factory default is enabled.
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port
Channel. The possible values are:
Disable - spanning tree is disabled for this Port Channel.
Enable - spanning tree is enabled for this Port Channel.
Static Mode - Select static or dynamic from the pull down menu. The factory default is
disabled.
Load Balance Mode - Select load balance mode from the pull down menu. The factory
default is Source XOR Destination MAC address.
Participation - For each port specify whether it is to be included as a member of this Port
Channel or not. The default is excluded. There can be a maximum of 8 ports assigned to a
Port Channel.
Non-Configurable Data
Slot/Port - Slot/Port identification of the Port Channel being configured. This field will not
To Next Page
Loading...
Need help?
General
