Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 622/970
10.1.2.7 cluster holdtime
This command will set holdtime of heartbeat of the cluster.
Syntax
cluster holdtime < second>
<second> - a unit issecond.
no - Resets to default value.
Default Setting
The default value is 80
Command Mode
Global Config
10.1.2.8 cluster heartbeat
This command will set interval of sending heartbeat packets among the switches of the cluster.
.
Syntax
cluster heartbeat <interval>
no cluster heartbeat
<interval> - a unit issecond.
no - This command will reset interval of sending heartbeat packets among the switches of
the cluster.
Default Setting
The default value is 8
Command Mode
Global Config
10.1.2.9 cluster rcommand member
This command is used to remotely manage the member switches in the cluster
.
To Next Page
Loading...
Need help?
General
