Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 859/970
Submit - Send the updated screen to the switch. Changes take effect on the switch but
these changes will not be retained across a power cycle unless a save is performed.
Download Certificates - Link to the File Transfer page for the SSL Certificate download.
Note that to download SSL Certificate files SSL must be administratively disabled.
11.2.4.6 Defining Secure Shell Configuration
11.2.4.6.1. Configuring Secure Shell Configuration Page
Configurable Data
Admin Mode - This select field is used to Enable or Disable the administrative mode of
SSH. The currently configured value is shown when the web page is displayed. The
default value is Disable.
SSH Version 1 - This select field is used to Enable or Disable Protocol Level 1 for SSH.
The currently configured value is shown when the web page is displayed. The default
value is Enable.
SSH Version 2 - This select field is used to Enable or Disable Protocol Level 2 for SSH.
The currently configured value is shown when the web page is displayed. The default
value is Enable.
Maximum Number of SSH Sessions Allowed - This select field is used to configure the
maximum number of inbound SSH sessions allowed on the switch. The currently
configured value is shown when the web page is displayed. The range of acceptable
values for this field is (0-5).
SSH Session Timeout (Minutes) - This text field is used to configure the inactivity
timeout value for incoming SSH sessions to the switch. The acceptable range for this
value is (1-160) minutes.
To Next Page
Loading...
Need help?
General
