QUANTA LB4M - Configuration Commands; Show Vtp Trunkport; Vtp

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 332/970
6.14.1.4 show vtp trunkport
This command displays the VTP trunkport status.
Syntax
show vtp trunkport
Default Setting
None
Command Mode
Privileged Exec
Display Message
Port: Displays the interface number.
Trunkport: Displays the trukport status (enable or disable) on the interface number.
6.14.2 Configuration Commands
6.14.2.1 vtp
This command uses to configure global VTP administrative mode.
Syntax
vtp
no vtp
no - This command disables global VTP administrative mode.
Default Setting
Disabled
Command Mode