QUANTA LB4M - Arp Resptime; Arp Retries; Arp Timeout

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 420/970
7.1.2.7 arp resptime
This command configures the ARP request response timeout.
Syntax
arp resptime <1-10>
no arp resptime
<1-10> - The range of default response time is 1 to 10 seconds.
no - This command configures the default response timeout time.
Default Setting
The default response time is 1.
Command Mode
Global Config
7.1.2.8 arp retries
This command configures the ARP count of maximum request for retries.
Syntax
arp retries <0-10>
no arp retries
<0-10> - The range of maximum request for retries is 0 to 10.
no - This command configures the default count of maximum request for retries.
Default Setting
The default value is 4.
Command Mode
Global Config
7.1.2.9 arp timeout
This command configures the ARP entry ageout time.
Syntax
arp timeout <15-21600>
no arp timeout
<15-21600> - Represents the IP ARP entry ageout time in seconds. The range is 15 to
21600 seconds.