Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 365/970
• hierarchical service policies not supported in a class definition
• access list matched by reference only, and must be sole criterion in a class
• that is, ACL rules copied as class match criteria at time of class creation, with class
type 'any'
• implicit ACL 'deny all' rule also copied
• no nesting of class type 'acl'
Regarding nested classes, referred to here as class references, a given class definition
can contain at most one reference to another class, which can be combined with other match
criteria. The referenced class is truly a reference and not a copy, since additions to a
referenced class affect all classes that reference it. Changes to any class definition currently
referenced by any other class must result in valid class definitions for all derived classes
otherwise the change is rejected. A class reference may be removed from a class definition.
The user can display summary and detailed information for classes, policies, and services.
All configuration information is accessible via the CLI, Web, and SNMP user interfaces.
6.18.1 General Commands
The following characteristics are configurable for the platform as a whole.
6.18.1.1 diffserv
This command sets the DiffServ operational mode to active. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled, Diffserv
services are activated.
Syntax
To Next Page
Loading...
Need help?
General
