Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 370/970
Syntax
match cos <0-7>
Default Setting
None
Command Mode
Class-Map Config
6.18.2.8 match destination-address mac
This command adds to the specified class definition a match condition based on the
destination MAC address of a packet. The <address> parameter is any layer 2 MAC address
formatted as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff).
The <mac-mask> parameter is a layer 2 MAC address bit mask, which need not be contiguous,
and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
ff:07:23:ff:fe:dc).
NOTE: This command is not available on the Broadcom 5630x platform.
Syntax
match destination-address mac <address> <mac-mask>
<address> - Specifies any layer 2 MAC address.
<mac-mask> - Specifies a layer 2 MAC address bit mask.
Default Setting
None
Command Mode
Class-Map Config
6.18.2.9 match dstip
This command adds to the specified class definition a match condition based on the