Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 497/970
Command Mode
Global Config
This command sets the virtual router ID on an interface for Virtual Router configuration in the
router.
Syntax
ip vrrp <1-255>
no ip vrrp <1-255>
<1-255> - The range of virtual router ID is 1 to 255.
<no> - This command removes all VRRP configuration details of the virtual router
configured on a specific interface.
Default Setting
None
Command Mode
Interface Config
7.9.2.2 ip vrrp ip
This commands also designates the configured virtual router IP address as a secondary IP
address on an interface.
Syntax
ip vrrp <1-255> ip <addr> [secondary]
no ip vrrp <1-255> ip
<addr> [secondary
]
<1-255> - The range of virtual router ID is 1 to 255.
<addr> - Secondary IP address of the router ID.
<no> - This command removes all VRRP configuration details of the virtual router
configured on a specific interface.
Default Setting
To Next Page
Loading...
Need help?
General
