Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 304/970
MAC-Address: A MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are separated by
colons, for example 01:23:45:67:89:AB. In an IVL system the MAC address will be displayed
as 8 bytes.
Mask: The mac-mask is the last eight digit of the mask code of the MAC address, the valid
values are: 0xff, 0xfe, 0xfc, 0xf8, 0xf0, 0xe0, 0xc0, 0x80 and 0x0.
Priority: The p
riority-id is the priority of the voice traffic; the valid range is 0 to 7.
6.11.1.2 show voice vlan
Use this command to
display the configuration status of the Voice VLAN on the switch, When the
interface parameter is not specified, only the global mode of the Voice VLAN is displayed.
Syntax
show voice vlan [ interface { <unit/slot/port> | all }]
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Voice VLAN Mode: The admin mode of the Voice VLAN on the interface.
Voice VLAN ID: The Voice VLAN ID.
Voice VLAN Priority: The dot1p priority for the Voice VLAN on the port.
Voice VLAN Untagged: The tagging option for the Voice VLAN traffic.
Voice VLAN CoS Override: The Override option for the voice traffic arriving on the port.
Voice VLAN Status: The operational status of Voice VLAN on the port.
6.11.2 Configuration Commands
6.11.2.1 voice-vlan
This command is used to enable/disable Voice VLAN Admin Mode.
To Next Page
Loading...
Need help?
General
