QUANTA LB4M - Distance Rip; Hostrouteaccept

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 484/970
Not configured
Command Mode
Router RIP Config
7.6.2.6 distance rip
This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route.
Syntax
distance rip <1-255>
no distance rip
<1 - 255> - the value for distance.
no - This command sets the default route preference value of RIP in the router.
Default Setting
15
Command Mode
Router RIP Config
7.6.2.7 hostrouteaccept
This command enables the RIP hostroutesaccept mode.
Syntax
hostrouteaccept
no hostrouteaccept
no - This command disables the RIP hostroutesaccept mode.