Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 385/970
<policyname> - Old Policy name.
<newpolicyname> - New policy name.
Command Mode
Global Config
Policy Type In
6.18.4
Service Commands
The 'service' command set is used in DiffServ to define:
Traffic Conditioning Assign a DiffServ traffic conditioning policy (as specified by
the policy commands) to an interface in the incoming
direction.
Service Provisioning Assign a DiffServ service provisioning policy (as specified
by the policy commands) to an interface in the outgoing
direction
The service commands attach a defined policy to a directional interface. Only one policy
may be assigned at any one time to an interface in a particular direction. The policy type (in,
out) must match the interface direction to which it is attached.
This set of commands consists of service addition/removal.
The CLI command root is service-policy
6.18.4.1 service-policy
This command attaches a policy to an interface in a particular direction.
Syntax
service-policy
in <policy-map-name>
The command can be used in the Interface Config mode to attach a policy to a specific
interface. Alternatively, the command can be used in the Global Config mode to attach this
policy to all system interfaces. The direction value is either in or out.
<policy-map-name> is the name of an existing DiffServ policy, whose type must match the
interface direction. Note that this command causes a service to create a reference to the policy.
To Next Page
Loading...
Need help?
General
