Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 250/970
script show <scriptname>
<scriptname> - Name of the script file.
Default Setting
None
Command Mode
Privileged Exec
6.7 User Account Management Commands
6.7.1 Show Commands
6.7.1.1 show users
This command displays the configured user names and their settings. This command is only
available for users with readwrite privileges. The SNMPv3 fields will only be displayed if SNMP
is available on the system.
Syntax
show users
Default Setting
None
Command Mode
Privileged Exec
Display Message
User Name: The name the user will use to login using the serial port, Telnet or Web. A new
user may be added to the switch by entering a name in a blank entry. The user name may
be up to eight characters, and is not case sensitive. Two users are included as the factory
default, admin, and guest.
User Access Mode: Shows whether the operator is able to change parameters on the
switch (Read/Write) or is only able to view them (Read Only). As a factory default, admin has
Read/Write access and guest has Read Only access. There can only be one Read/Write
To Next Page
Loading...
Need help?
General
