Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 284/970
6.8.4.7 radius-server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted
to the RADIUS server if no response is received. The timeout value is an integer in the range of
1 to 30.
Syntax
radius-server timeout <seconds>
no radius-server timeout
<seconds> - the maximum timeout (Range: 1 - 30).
no - This command sets the timeout value (in seconds) after which a request must be
retransmitted to the RADIUS server if no response is received, to the default value, that is,
6.
Default Setting
6
Command Mode
Global Config
6.8.4.8 radius-server msgauth
This command enables the message authenticator attribute for a specified server.
Syntax
radius-server msgauth <ipaddr>
<ipaddr> - is a IP address.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...
Need help?
General
