Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 295/970
Interface Config
This command is used to enable CDP for all interfaces.
Syntax
cdp run all
no cdp run all
all - All interfaces.
no - This command is used to disable CDP for all interfaces.
Default Setting
Enabled
Command Mode
Global Config
6.9.2.3 cdp timer
This command is used to configure an interval time (seconds) of the sending CDP packet.
Syntax
cdp timer <5-254>
no cdp timer
<5-254> - interval time (Range: 5 – 254).
no - This command is used to reset the interval time to the default value.
Default Setting
60
To Next Page
Loading...
Need help?
General
