QUANTA LB4M - DHCP Relay Commands; Ip Dhcp Client-Identifier; Show Bootpdhcprelay

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 214/970
6.3.8.2 ip dhcp client-identifier
This command is used to specify the DCHP client identifier for this switch. Use the no form to
restore to default value.
Syntax
ip dhcp client-identifier {text <text> | hex <hex>}
no ip dhcp client-identifier
<text> - A text string. (Range: 1-15 characters).
<hex> - The hexadecimal value (00:00:00:00:00:00).
no - This command is used to restore to default value.
Default Setting
System Burned In MAC Address
Command Mode
Global Config
6.3.9 DHCP Relay Commands
6.3.9.1 show bootpdhcprelay
This command is used to display the DHCP relay agent configuration information on the
system.
Syntax
show bootpdhcprelay
Default Setting
None