QUANTA LB4M - Snmptrap Link-Status

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 200/970
Syntax
snmptrap snmpversion <name> <ipaddr> <snmpversion>
Default Setting
Snmpv2
Command Mode
Global Config
6.3.5.3 snmptrap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See ‘snmpserver
enable traps linkmode’ command.
Syntax
snmptrap link-status
no snmptrap link-status
no - This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. (See
‘snmpserver enable traps linkmode’ command.)
Default Setting
Disabled
Command Mode
Interface Config