Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 239/970
no spanning-tree mst <0-4094> port-priority
<0-4094> - multiple spanning tree instance ID.
no - This command sets the Path Cost or Port Priority for this port within the multiple
spanning tree instance or in the common and internal spanning tree to the respective
default values. If the <0-4094> parameter corresponds to an existing multiple spanning
tree instance, then the configurations are done for that multiple spanning tree instance. If
however, 0 (defined as the default CIST ID) is passed as the <0-4094>, then the
configurations are performed for the common and internal spanning tree instance.
If the ‘port-priority’ token is specified, this command sets the priority for this port within a
specific multiple spanning tree instance or the common and internal spanning tree
instance, depending on the <0-4094> parameter, to the default value, that is, 128.
Default Setting
port-priorty : 128
Command Mode
Interface Config
6.4.2.10 spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Syntax
To Next Page
Loading...
Need help?
General
