Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 238/970
Syntax
spanning-tree mst <0-4094> cost {<1-200000000> | auto}
no spanning-tree mst <0-4094> cost
<0-4094> - multiple spanning tree instance ID.
no - This command sets the Path Cost or Port Priority for this port within the multiple
spanning tree instance or in the common and internal spanning tree to the respective
default values. If the <0-4094> parameter corresponds to an existing multiple spanning
tree instance, then the configurations are done for that multiple spanning tree instance. If
however, 0 (defined as the default CIST ID) is passed as the <0-4094>, then the
configurations are performed for the common and internal spanning tree instance.
If the ‘cost’ token is specified, this command sets the path cost for this port within a
multiple spanning tree instance or the common and internal spanning tree instance,
depending on the <0-4094> parameter, to the default value, that is, a pathcost value
based on the Link Speed.
Default Setting
Cost : auto
Command Mode
Interface Config
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree. If the <0-4094> parameter corresponds
to an existing multiple spanning tree instance, then the configurations are done for that multiple
spanning tree instance. If however 0 (defined as the default CIST ID) is passed as the
<0-4094>, then the configurations are performed for the common and internal spanning tree
instance.
If the ‘port-priority’ token is specified, this command sets the priority for this port within a
specific multiple spanning tree instance or the common and internal spanning tree instance,
depending on the <0-4094> parameter. The port-priority value is a number in the range of 0 to
240 in increments of 16.
Syntax
To Next Page
Loading...
Need help?
General
