Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 237/970
This command adds an association between a multiple spanning tree instance and a VLAN.
The VLAN will no longer be associated with the common and internal spanning tree. The
instance <0-4094> is a number that corresponds to the desired existing multiple spanning tree
instance. The <1-3965> corresponds to an existing VLAN ID.
Syntax
spanning-tree mst vlan <0-4094> <1-3965>
no spanning-tree mst vlan <0-4094> <1-3965>
<0-4094> - multiple spanning tree instance ID.
<1-3965> - VLAN ID (Range: 1 – 3965).
no - This command removes an association between a multiple spanning tree instance
and a VLAN. The VLAN will again be associated with the common and internal spanning
tree. The instance <0-4094> is a number that corresponds to the desired existing multiple
spanning tree instance. The <1-3965> corresponds to an existing VLAN ID.
Default Setting
None
Command Mode
Global Config
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree. If the <0-4094> parameter corresponds
to an existing multiple spanning tree instance, then the configurations are done for that multiple
spanning tree instance. If however 0 (defined as the default CIST ID) is passed as the
<0-4094>, then the configurations are performed for the common and internal spanning tree
instance.
If the ‘cost’ token is specified, this command sets the path cost for this port within a multiple
spanning tree instance or the common and internal spanning tree instance, depending on the
<0-4094> parameter. The pathcost can be specified as a number in the range of 1 to
200000000 or auto. If "auto" is specified, the pathcost value will be set based on Link Speed.
To Next Page
Loading...
Need help?
General
