Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 236/970
reallocates all VLANs allocated to the deleted instance to the common and internal
spanning tree. The instance <1-4094> is a number that corresponds to the desired
existing multiple spanning tree instance to be removed.
Default Setting
None
Command Mode
Global Config
This command sets the bridge priority for a specific multiple spanning tree instance. The
instance <mstid> is a number that corresponds to the desired existing multiple spanning tree
instance. The priority value is a number within a range of 0 to 61440 in increments of 4096.
If 0 (defined as the default CIST ID) is passed as the <mstid>, then this command sets the
Bridge Priority parameter to a new value for the common and internal spanning tree. The
bridge priority value again is a number within a range of 0 to 61440. The twelve least significant
bits will be masked according to the 802.1s specification.
This will cause the priority to be rounded down to the next lower valid priority.
Syntax
spanning-tree mst priority <0-4094> <0-61440>
no spanning-tree mst priority <0-4094>
<0-4094> - multiple spanning tree instance ID.
<0-61440> - priority value (Range: 0 – 61440).
no - This command sets the bridge priority for a specific multiple spanning tree instance to
the default value, that is, 32768. The instance <0-4094> is a number that corresponds to
the desired existing multiple spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the <0-4094>, then this command sets
the Bridge Priority parameter for the common and internal spanning tree to the default
value, that is, 32768.
Default Setting
32768
Command Mode
Global Config
To Next Page
Loading...
Need help?
General
