QUANTA LB4M - Radius Accounting Mode; Radius Configuration Commands; Radius Server Attribute 4

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 280/970
no - This command sets the timer used by authenticator state machine on this port to the
default value.
Default Setting
90
Command Mode
Global Config
6.8.4 Radius Configuration Commands
6.8.4.1 radius accounting mode
This command is used to enable the RADIUS accounting function.
Syntax
radius accounting mode
no radius accounting mode
no - This command is used to set the RADIUS accounting function to the default value -
that is, the RADIUS accounting function is disabled.
Default Setting
Disabled
Command Mode
Global Config
6.8.4.2 radius server attribute 4
This command to set the NAS-IP address for the radius server.
Syntax