QUANTA LB4M - Ip Pimdm Query-Interval; Protocol Independent Multicast - Sparse Mode (PIM-SM) Commands

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 534/970
Syntax
ip pimdm mode
no ip pimdm mode
no - This command sets administrative mode of PIM-DM on an interface to disabled.
Default Setting
Disabled
Command Mode
Interface Config
8.4.2.3 ip pimdm query-interval
This command configures the transmission frequency of hello messages between PIM enabled
neighbors. This field has a range of 10 to 3600 seconds.
Syntax
ip pimdm query-interval <10 - 3600>
no ip pimdm query-interval
<10 - 3600> - This is time interval in seconds.
no - This command resets the transmission frequency of hello messages between PIM
enabled neighbors to the default value.
Default Setting
30
Command Mode
Interface Config
8.5 Protocol Independent Multicast – Sparse Mode (PIM-SM) Commands