QUANTA LB4M - External-Lsdb-Limit; Ip Ospf Areaid

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 461/970
<no> - This command configures the default exit overflow interval for OSPF.
Default Setting
The default value of exit overflow interval for OSPF is 0.
Command Mode
Router OSPF Config
7.3.2.25 external-lsdb-limit
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no
limit. When the number of non-default AS-external-LSAs in a router's link-state database
reaches the external LSDB limit, the router enters overflow state. The router never holds more
than the external LSDB limit non-default AS-external-LSAs in it database. The external LSDB
limit MUST be set identically in all routers attached to the OSPF backbone and/or any regular
OSPF area.
Syntax
external-lsdb-limit <-1-2147483647>
no external-lsdb-limit
<-1-2147483647> - The range of external LSDB limit for OSPF is -1 to 2147483674.
<no> - This command configures the default external LSDB limit for OSPF.
Default Setting
The default value of external LSDB limit for OSPF is -1.
Command Mode
Router OSPF Config
7.3.2.26 ip ospf areaid
This command sets the OSPF area to which the specified router interface belongs. Assigning