Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 192/970
This command activates an SNMP community. If a community is enabled, an SNMP manager
associated with this community manages the switch according to its access right. If the
community is disabled, no SNMP requests using this community are accepted. In this case the
SNMP manager associated with this community cannot manage the switch until the Status is
changed back to Enable.
Syntax
snmp-server community mode <name>
no snmp-server community mode <name>
<name> - community name.
no - This command deactivates an SNMP community. If the community is disabled, no
SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed back
to Enable.
Default Setting
The default public and private communities are enabled by default. The four undefined
communities are disabled by default.
Command Mode
Global Config
This command sets a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP address value to
denote a range of IP addresses from which SNMP clients may use that community to access
the device. A value of 255.255.255.255 will allow access from only one station, and will use
that machine's IP address for the client IP Address. A value of 0.0.0.0 will allow access from
any IP address. The name is the applicable community name.
Syntax
To Next Page
Loading...
Need help?
General
