Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 900/970
OSPFv3 Inter - The OSPFv3 inter route preference value in the router. The default value
is 10. The range is 1 to 255. The OSPFv3 specification requires that preferences must be
given to the routes learned via OSPFv3 in the following order: intra < inter < type-1 <
type-2 .
OSPFv3 Type-1 - The OSPFv3 Type-1 route preference value in the router. The default
value is 13. The range is 1 to 255. The OSPFv3 specification requires that preferences
must be given to the routes learned via OSPFv3 in the following order: intra < inter <
type-1 < type-2 .
OSPFv3 Type-2 - The OSPFv3 intra route preference value in the router. The default
value is 150. The range is 1 to 255. The OSPFv3 specification requires that preferences
must be given to the routes learned via OSPFv3 in the following order: intra < inter <
type-1 < type-2 .
Non-Configurable Data
Local - Local preference.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is
performed.
11.2.5.9.4. Configuring IPv6 Routes Configuration Page
Selection Criteria
Routes Displayed -
•
Configured Routes - Shows the routes configured by the user
•
Best Routes - Shows only the best active routes
•
All Routes - Shows all active IPv6 routes
To Next Page
Loading...