EasyManua.ls Logo

QUANTA LB4M - Page 862

QUANTA LB4M
970 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 862/970
Maximum Transmit Unit - Specifies maximum trasmit unit on an interface. If the value is 0
then this interface is not enabled for routing. It is not valid to set this value to 0 if routing is
enabled. Range of MTU is (1280 to 1500)
Duplicate Address Detection - Specifies number of duplicate address detections
transmits on an interface. DAD transmits values must be in range (0 to 600)
Neighbor solicit Interval - Specifies retransmission time field of router advertsisement
sent from the interface. A value of 0 means interval is not specified for router. Range of
neighbor solicit interval is (1000 to 4294967295)
Router Lifetime - Specifies router advertisement lifetime field sent from the interface. This
value must be greater than or equal to maximum advertisement interval. 0 means do not
use router as default router. Range of router lifetime is (0 to 9000)
Reachable Time - Specifies router advertisement time to consider neighbor reachable
after ND confirmation. Range of reachable time is (0 to 3600000)
Router Advertisement Interval - Specifies maximum time allowed between sending
router advertisements from the interface. Default value is 600. Range of maximum
advertisement interval is (4 to 1800)
Managed Config Flag - Specifies router advertisement managed address configuration
flag. When true, end nodes use DHCPV6. When false end nodes autoconfigure addresses.
Default value of managed flag is disable.
Other Config Flag - Specifies router advertisement other stateful configuration flag.
Default value of other config flag is disable.
Suppress Flag - Specifies router advertisement suppression on an interface. Default
value of suppress flag is disable.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is
performed.
Delete - Delete the IPv6 Address configured on an interface.

Table of Contents

Related product manuals