Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 104/970
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).
no - This command removes the protocol-based VLAN group that is identified by this
<group-name>.
Default Setting
None
Command Mode
Global Config
This command adds all physical interfaces to the protocol-based VLAN identified by
<group-name>. A group may have more than one interface associated with it. Each interface
and protocol combination can only be associated with one group. If adding an interface to a
group causes any conflicts with protocols currently associated with the group, this command
will fail, and the interface(s) will not be added to the group.
Syntax
switchport protocol group all <group-name>
no switchport protocol group all <group-name>
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).
all - All interfaces.
no - This command removes all interfaces from this protocol-based VLAN group that is
identified by this <group-name>.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...