Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 155/970
used to be set for port-channel load balance.
Syntax
port-channel load-balance all { src-mac| dst-mac | dst-src-mac | src-ip | dst-
dst-src-ip }
no port-channel load-balance all
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
dst-src-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
dst-ip - Sets the mode on the destination IP address.
dst-src-ip - Sets the mode on the source and destination IP addresses.
no - Restore the mode to be default value.
Default Setting
dst-src-ip
Command Mode
Global Config
This command for CLI will configured the mode of load balance on the specific Port Channel.
The parameter “
src-mac | dst-mac | dst-src-mac | src-ip | dst-ip| dst-src-ip
” represent the
mode used to be set for port-channel load balance.
Syntax
load-balance { src-mac| dst-mac | dst-src-mac | src-ip | dst-ip| dst-src-ip }
no load-balance
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
dst-src-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
To Next Page
Loading...
Need help?
General
