Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 644/970
Password History - The number of previous passwords to store for prevention of
password reuse. This ensures that each user does not reuse passwords often. A value of 0
indicates that no previous passwords will be stored.
Lockout Attempts - The number of allowable failed local authentication attempts before
the user's account is locked. A value of 0 indicates that user accounts will never be locked.
Command Buttons
Submit - Send the updated screen to the switch and cause the changes to take effect on
the switch. These changes will not be retained across a power cycle unless you perform a
save.
11.2.1.3.15. Defining Denial Of Service Page
Configurable Data
Denial of Service SIP=DIP - Enable or disable this option by selecting the corresponding
line on the pulldown entry field. Enabling SIP=DIP DoS prevention causes the switch to
drop packets that have a source IP address equal to the destination IP address. The
factory default is disabled.
Denial of Service First Fragment - Enable or disable this option by selecting the
corresponding line on the pulldown entry field. Enabling First Fragment DoS prevention
causes the switch to drop packets that have a TCP header smaller then the configured Min
TCP Hdr Size. The factory default is disabled.
Denial of Service Min TCP Hdr Size - Specify the Min TCP Hdr Size allowed. If First
Fragment DoS prevention is enabled, the switch will drop packets that have a TCP header
smaller then this configured Min TCP Hdr Size. The factory default is disabled.
Denial of Service TCP Fragment - Enable or disable this option by selecting the
corresponding line on the pulldown entry field. Enabling TCP Fragment DoS prevention
causes the switch to drop packets that have an IP fragment offset equal to 1. The factory
default is disabled.
To Next Page
Loading...
Need help?
General
