Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 68/970
<slot/port> - is the desired interface number.
all - This command displays statistics information for all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
The display parameters when the argument is '<slot/port>' are as follows:
Packets Received Without Error: The total number of packets (including broadcast
packets and multicast packets) received by the processor.
Packets Received With Error: The number of inbound packets that contained errors
preventing them from being deliverable to a higher-layer protocol.
Broadcast Packets Received: The total number of packets received that were directed to
the broadcast address. Note that this does not include multicast packets.
Packets Transmitted Without Error: The total number of packets transmitted out of the
interface.
Transmit Packets Errors: The number of outbound packets that could not be transmitted
because of errors.
Collisions Frames: The best estimate of the total number of collisions on this Ethernet
segment.
Time Since Counters Last Cleared: The elapsed time, in days, hours, minutes, and
seconds since the statistics for this port were last cleared.
The display parameters when the argument is 'all' are as follows:
Interface: The physical slot and physical port or the logical slot and logical port.
Summary: The summation of the statistics of all ports.
Packets Received Without Error: The total number of packets (including broadcast
packets and multicast packets) received.
Packets Received With Error: The number of inbound packets that contained errors
preventing them from being deliverable to a higher-layer protocol.
Broadcast Packets Received: The total number of packets received that were directed to
the broadcast address. Note that this does not include multicast packets.
Packets Transmitted Without Error: The total number of packets transmitted.
Transmit Packets Errors: The number of outbound packets that could not be transmitted
because of errors.
Collisions Frames: The best estimate of the total number of collisions on this Ethernet
segment.
This command displays detailed statistics for a specific port or for all CPU traffic based upon
the argument.
To Next Page
Loading...
Need help?
General
